Amana Tool Straight Plunge Downshear Polycrystalline Diamond (PCD)-Tipped 1/4 Dia x 12.32mm (1/2) x 1/4 Shank Single Flute Router Bit

Thank you for shopping with us!

Diamond is the hardest naturally-occuring material on the earth. Polycrystalline Diamond (PCD) tooling is manufactured in a high-temperature and high-pressure laboratory that fuses diamond particles onto a carbide substrate, which allows the diamond to be brazed onto a tool body.

If you’re looking for the ultimate in tooling, you’ve found it! Amana Tool®’s PCD-tipped double flute straight plunge router bits will groove and joint a wide variety of tough abrasive materials including composites, particleboard, MDF (both raw or with melamine), veneer, and hardwoods. The cutting edge lasts much longer than carbide for extremely long life.

Excellent for Cutting:

Aluminum
Aluminum Composites
Aluminum Composite Material (ACM)
Composites
Composite Panels
Custom Composite Materials (CCM)
Fiberglass
Fiberglass PCB Board
Fiberglass Reinforced Composites
Fiber-Reinforced Urethane
Fiber-Reinforced Structural Foam Floors
Hard and Soft Wood
Lightweight Composites
MDF
Plastic

Benefits of Diamond Technology
Harder cutting edge provides higher resistance to wear
Cut thousands of feet more than carbide without changing tool saving setup time
Optimized machine tool efficiency
Quality of finish is often significantly improved